







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in San Juan Capistrano, CA: Cost and Timeline
A tub-to-shower conversion in San Juan Capistrano runs $3,500 to $10,000 and takes three to six working days once permits clear. The tub and its surround come out, the drain gets repositioned if the new shower footprint calls for it, and a waterproofed shower base, walls and valve go in. Most conversions here land near $9,000 to $12,000 once tile, glass and fixture grade are chosen. Call (888) 255-9354 to book a free on-site estimate.
How We Run a Tub-to-Shower Conversion, Start to Finish

Every conversion follows the same five stages. Here’s what actually happens, and when you’ll need to make decisions.
Stage 1: Site assessment and layout (half a day)
We measure the alcove, the drain location, the water lines and the wall framing. This is when you decide the finished footprint: standard 60-inch alcove, wider curbed shower, or a curbed walk-in. You also pick a curb height and slope class now, because it drives the base spec. If the old tub sits on a raised platform, we talk about whether to drop the floor or keep the step. That choice is the biggest single cost lever and it’s locked in at this stage, not later.
Stage 2: Demo and rough-in inspection (one to two days)
Out goes the tub, the valve trim, the surround and any rotten framing behind it. We expose the drain and mixing valve and check the condition of the subfloor. This is where surprise finds turn up: a cracked cast-iron drain, a rotted joist from a slow leak under the old tub, a galvanized supply line that needs replacing. We photograph everything before it’s covered. The rough plumbing and electrical (if you’re adding a light or fan) get inspected at this point if the permit scope requires it.
Stage 3: Waterproofing (one day)
This is the stage that decides whether a shower lasts decades or fails in five years. We build a sloped base, set the pan liner or bonded waterproofing membrane, and seal every joint and penetration. A proper flood test happens before tile goes on. It’s not glamorous work, and it’s not visible once finished, but a shower without it will leak into the ceiling below. We don’t compress this stage.
Stage 4: Tile, glass and fixtures (two to three days)
Tile goes on walls and floor, grout cures, then the trim kit, valve, showerhead and glass panels set. You’ll have chosen the tile, grout, fixture finish (brushed nickel, matte black, chrome, or oil-rubbed bronze) and glass type by now. Frameless glass runs add time because the panels are custom-templated and fabricated. If you’re keeping a prefabricated surround rather than tile, this stage drops to a single day.
Stage 5: Final inspection and walkthrough (half a day)
We run the shower, check slope and drainage, inspect every sealed joint, and walk the finished job with you. A tile-and-glass conversion here is typically done in three to six days from demo. A prefab surround is often one to two days. The 730-Day Done Right Promise covers the workmanship on all of it, so if a seal fails or a tile lifts, we come back and fix it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Your Choice of Materials for a San Juan Capistrano Conversion
The material and configuration decisions move both cost and lifespan more than anything else on this job. Here’s the honest breakdown.
- Prefabricated acrylic or fiberglass surround – the lowest-cost route, roughly $1,000 to $2,500 installed. Fast (one to two days), easy to clean, no grout to maintain. The trade-off is a plastic feel and a limited color range, and the material can flex or yellow over a decade-plus in a hot, sunny room.
- Ceramic or porcelain tile over a waterproofed base – the most common choice in this market, roughly $3,500 to $8,000 for the tile and labor portion. Durable, easy to match to a San Juan Capistrano Spanish Colonial or Craftsman interior, and repairable. Porcelain holds up better than ceramic in a shower that gets daily use.
- Natural stone (travertine, marble, slate) – the high end, adding $2,000 to $5,000 or more. Beautiful, but it’s porous, needs sealing every one to two years, and softer stones etch. Suits a homeowner who wants a period-appropriate look and will keep up with maintenance.
- Linear or center drain – a linear drain makes a curbless or low-curb entry possible and looks cleaner, but it costs $800 to $2,000 more and the slope is harder to build. A center drain is standard and cheaper.
- Glass enclosure: framed vs. frameless – framed glass is budget-friendly and forgiving of slight wall out-of-square, common in older homes. Frameless glass, about $800 to $2,500, gives the cleanest look but demands square walls and custom-templated panels.
A Kohler or Moen valve and trim package is a fine middle ground if you don’t want builder-grade fixtures. On cabinetry in a nearby vanity update, KraftMaid and Wellborn are the brand names we most often bring into a bathroom that’s being done at the same time.
What Tub-to-Shower Conversion Costs in San Juan Capistrano, CA

Expect $3,500 to $10,000 for a tub-to-shower conversion in San Juan Capistrano. The low end is a prefab surround on an existing drain; the high end is tile walls, frameless glass, a new valve and a curbless base. Four to five variables decide where a given job lands:
- Footprint and curb: a standard 60-inch alcove keeping the existing drain sits at the low end. Widening the shower, dropping a platform tub to floor level, or going curbless means moving the drain and re-framing, which adds $800 to $2,500.
- Hidden condition: a rotten subfloor, a failing drain, or old galvanized lines exposed at demo add $300 to $1,800 depending on what’s found. This is why an on-site estimate matters more than a phone quote.
- Material grade: prefab surround to natural stone spans roughly $2,500 in material and labor. Tile selection alone can swing a job by $3,000.
- Plumbing and electrical relocation: adding a light, exhaust fan or moving the valve to the opposite wall adds $200 to $1,200.
- Permit scope: a permit for drain relocation or plumbing changes adds a few hundred dollars and a few days of inspection scheduling. A like-for-like swap on the same drain may not need one.
A written estimate here is line-item, with the number you see and the number you pay. It includes demo, rough-in, waterproofing, tile or surround, fixtures, glass installation, cleanup, and haul-away. What’s not included: structural repair if hidden rot is found, moving a toilet or sink, or any work outside the alcove. Those are quoted separately once we see the condition.
See the difference
Before
After
Before
After
Before
AfterWhat San Juan Capistrano Homes Do to This Job
San Juan Capistrano isn’t a uniform tract town, and the conversion reflects that. In the historic downtown and around the Mission corridor, homes carry adobe, Craftsman and Spanish Colonial Revival construction, some dating to the 18th and 19th centuries. In those walls, replacing a tub can expose hand-shaped framing, older copper or galvanized supply lines, and subfloors that don’t meet modern flat. We plan the waterproofing and drain slope around the actual framing, not a drawing. Mid-century ranch homes on the outskirts and newer builds in San Juan Hills are more predictable, but they still show the wear of a marine-influenced, semi-arid climate: dry summers crack grout, and winter rain finds any weak seal around a shower base.
The bigger local variable is the historic overlay. A tub-to-shower conversion is interior work, so it usually stays clear of street-visible design review and the Cultural Heritage Commission. But if your shower sits against a wall with a street-facing window, or you’re adding a vent that changes the exterior, the scope can trigger design review for anything visible from the street. In the historic core and Mission corridors, that means reviewing archival documentation before the permit is filed. We handle that step, and it’s a conversation worth having on the first visit. It’s also why a rigid template timeline doesn’t work here. We work with the City of San Juan Capistrano’s permitting process, which for historic-resource properties can add review time. We cover 92675 and 92693, and homeowners in San Juan Capistrano often pair the conversion with a roof or exterior update; if you’re planning tile work on the house itself, that’s Tile Roofing in San Juan Capistrano, and if you’re after metal, Metal Roofing in San Juan Capistrano. This conversion is also a natural part of our Bathroom Remodeling work across San Juan Capistrano, and if the change expands past the shower and into the rest of the bath, it becomes Bathroom Remodeling in San Juan Capistrano in full.
Serving San Juan Capistrano, CA – Our Local Coverage Area
We serve San Juan Capistrano and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in San Juan Capistrano

Most conversions take three to six working days from demo to finished shower. A prefab surround on the existing drain runs one to two days. Tile walls, a new valve, a curbless base and frameless glass push toward the six-day mark. Historic-resource properties may add a few days for permit and review scheduling. Call (888) 255-9354 for a timeline against your specific home.
You need a permit when the drain, supply plumbing, electrical or framing changes. A like-for-like swap keeping the existing drain often doesn’t. In San Juan Capistrano’s historic core, street-visible changes or work on a historic-resource property can trigger documented design review, so we confirm scope before demo. We walk through which permits apply at the free estimate. Call (888) 255-9354 to check your address.
Yes, and it’s the fastest route. Keeping the drain and valve where they sit lets us demo and rebuild within a standard 60-inch alcove. Moving the drain is what adds cost and inspection time. On older homes the answer sometimes depends on what demo exposes, so we plan for the common case and flag structural surprises in writing before proceeding.
Most jobs run $3,500 to $10,000. Prefab surrounds sit at the low end; tile, natural stone, a curbless base and frameless glass push toward the high end. Hidden rot or a bad drain adds $300 to $1,800. A written line-item estimate shows exactly what’s included before you commit. Call (888) 255-9354 and estimates are free.
Every tub-to-shower conversion is backed by the 730-Day Done Right Promise: if the workmanship fails, we make it right for two years. That covers waterproofing, tile, and seal work. It’s one of the longest workmanship guarantees in residential construction. Call (888) 255-9354 with questions about coverage.
Schedule Your Free Tub-to-Shower Conversion Estimate
Call (888) 255-9354 to schedule a free on-site estimate for your tub-to-shower conversion in San Juan Capistrano. We’ll measure the alcove, look at the plumbing and framing, and hand you a written line-item estimate with a fixed price and no hidden add-ons. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available. A live person answers around the clock. No voicemail, no waiting for Monday.
Written by the team at Groundwork Construction Co.












