







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Laguna Hills: What It Costs and How Long It Takes
Vanities, tile and fixtures in Laguna Hills usually runs $9,000 – $28,000 for a full bathroom’s worth of work, and most projects finish in two to three weeks once materials land. A vanity-only swap sits near the low end; new floor and shower tile, a relocated vanity, and a full fixture package push toward the high end. Call (888) 255-9354 for a free on-site estimate and a written line-item price.
How the Work Actually Moves, Day by Day

Bathroom finish work is a sequence, and the order matters more than the speed. Here’s what the calendar looks like when we run vanities, tile and fixtures in Laguna Hills.
Days 1 – 2: Demo and rough-in
We pull the old vanity, mirror, toilet, and floor covering, then inspect what’s behind them. In 1970s tract homes this is where surprises live: a shutoff valve that crumbles, a flange that’s rusted through, or a supply line that was already patched once. You decide here whether to replace the shutoffs and angle stops while the wall is open, which is the cheapest time to do it. Demo and rough-in run two days on a standard 5×8 bath.
Day 3: Subfloor, backer board, and waterproofing
Tile survives on what’s under it. We set cement backer board and a bonded waterproof membrane in the wet zone, then check for level and slope toward the drain. This is the stage most homeowners never see and most failures trace back to. Budget one full day. If the subfloor is soft from an old leak, we address it now, not after the tile is down.
Days 4 – 7: Tile setting
Floor tile typically goes first, then wall and shower tile. Large-format tile (12×24 and up) sets faster per square foot but demands a flatter substrate; small hex or mosaic takes longer because there’s more grout line and more cutting around fixtures. You’ll pick grout color and joint width before this stage starts. Plan three to four working days for a typical Laguna Hills bath.
Days 8 – 10: Grout, seal, and fixtures
Grout cures, then we seal natural stone and any cementitious grout. The vanity sets, the faucet and drain connect, the toilet resets, and the mirror and accessories go up. This is where you decide the finish package: brushed nickel versus matte black, single-hole versus widespread faucet, undermount versus farmhouse sink. Those choices usually need to be locked a week before install so nothing sits in a box on your patio.
Days 11 – 14: Punch list and walkthrough
We test every valve, check for leaks under the cabinet, verify the tile lines, and walk the room with you. Anything that doesn’t pass gets fixed before we call it done. The whole job falls under the 730-Day Done Right Promise, so a grout line that cracks or a faucet that drips in month eight gets handled.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Vanity, Tile and Fixture Options You’ll Weigh
Most of the budget decision happens in three categories. Here’s the honest trade-off on each.
- Vanity cabinet stock vs. semi-custom: Big-box stock runs $400 – $900 and fits standard 24-, 30-, or 36-inch openings. Semi-custom, like a KraftMaid line, runs $1,200 – $2,500 and lets you match a 1970s wall that isn’t perfectly plumb or set a non-standard depth. Stock is faster; semi-custom fits the room actually in front of you.
- Vanity top material: Cultured marble at $150 – $400 is the budget pick and holds up fine. Quartz runs $400 – $900 and resists staining and etching better. Granite is in the same range and each slab is unique, which some homeowners love and others find hard to match to tile.
- Floor tile: porcelain vs. natural stone: Porcelain at $3 – $8 per square foot installed is dense, water-resistant, and forgiving. Travertine or marble looks warmer but needs sealing every year or two and etches from citrus and cleaners. In a hall bath, porcelain usually wins on upkeep.
- Shower wall tile: Ceramic is the value option; porcelain and glass mosaic read more custom and cost more per foot. Large-format slabs mean fewer grout lines to clean but fewer places to hide a wall that’s out of square.
- Fixtures: the finish package: A basic chrome faucet runs $80 – $200; a widespread brushed-nickel or matte-black set runs $200 – $500. Kohler and similar lines hold finish longer than off-brand imports. Match the shower trim, sink faucet, and towel bars in one order so dye lots and finishes agree.
What Vanities, Tile & Fixtures Costs in Laguna Hills, CA

The full range for this work in Laguna Hills is $9,000 – $28,000. A vanity and fixture refresh with no tile lands near $9,000. A gut of the finish surfaces with new floor, shower tile, vanity, and all fixtures lands near the top. Here’s what moves the number:
| Line item | Typical range |
|---|---|
| Bathroom vanity installation | $800 – $3,000 |
| Floor and wall tile, installed | $2,500 – $8,000 |
| Fixture package (faucet, shower trim, toilet, accessories) | $600 – $2,500 |
| Waterproofing and substrate prep | $800 – $2,200 |
| Plumbing rough-in changes, if relocating | $700 – $2,500 |
Five variables push a Laguna Hills job toward the high end. Size, first: a 5×8 hall bath and a 10×12 primary bath are different jobs. Existing condition, second: original 1970s plumbing that’s already failing adds repair before finish. Relocation, third: moving the vanity or shower drain means cutting the slab or opening a wall. Material grade, fourth: travertine and large-format porcelain cost more than standard ceramic. And permit scope, fifth: a direct swap typically needs no permit, but adding a circuit for a heated floor or moving a drain line does. A written estimate lists each of these separately, so you see what’s included and what isn’t. Call (888) 255-9354 with your square footage and we’ll give you a firm number after we see the room.
See the difference
Before
After
Before
After
Before
AfterWhat Laguna Hills Homes Specifically Do to This Job
Most of the bathrooms we finish in Laguna Hills sit inside homes built by the Mission Viejo Company in the 1970s, when the area grew up around the Laguna Hills Mall and the I-5/SR-73 junction. That build era matters. The original vanities were often 30-inch oak boxes with cultured marble tops, and the shutoff valves behind them are now decades old. When we open a wall in a 92653 tract home, we expect to find galvanized or early copper supply lines that are past their service life. It’s common to recommend a shutoff replacement mid-project rather than put a new vanity over a valve that will fail in two years.
The tract plans also help us bid faster. Because so many homes on the same street share a layout, we can anticipate where the bearing walls and plumbing chases sit, which shortens planning and reduces the chance of opening a wall in the wrong place. HOA rules vary by association here, and some townhome communities require approval before any exterior vent or fan change, so check before you book. The warm, dry inland climate works in our favor for scheduling; we can run tile and fixture work through most of the year. If you’re already planning a wider project, this work folds naturally into a Bathroom Remodeling in Laguna Hills, and some homeowners pair an interior refresh with exterior work like Tile Roofing in Laguna Hills or Specialty Roofing in Laguna Hills while the house is already in project mode. You can read more about the wider service on our Bathroom Remodeling page, and see the full area we cover on the Laguna Hills page.
Serving Laguna Hills, CA – Our Local Coverage Area
We serve Laguna Hills and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Vanities, Tile & Fixtures in Laguna Hills

Most jobs run two to three weeks of working days once materials arrive. Vanity-only swaps take one to two days; a full floor-and-shower tile job with a new vanity takes closer to three weeks. Material lead times add the real variance, so lock your tile and vanity order early. Call (888) 255-9354 for a schedule after we see the room.
Cosmetic work like re-tiling an existing shower or swapping a vanity in the same spot usually doesn’t require a permit. Moving a drain, adding a circuit for a heated floor, or changing a fixture’s supply location does. We pull the permits required and pass the inspections, and the written estimate tells you which side of that line your job falls on. Call (888) 255-9354 to confirm your scope.
Yes, and that’s the most common version of this job. A cosmetic refresh that keeps the vanity, toilet, and shower in their current locations adds no plumbing rough-in cost and finishes faster. If you want to relocate the vanity or shift the shower drain, that changes the scope and the price. Call (888) 255-9354 and we’ll tell you which category your plan is in.
The range is $9,000 – $28,000, with vanity installation alone at $800 – $3,000 and tile work at $2,500 – $8,000. The exact number depends on room size, existing plumbing condition, material grade, and whether you relocate anything. Call (888) 255-9354 for a free written quote with every line itemized.
Every vanity, tile and fixture job is covered by the 730-Day Done Right Promise, which runs two full years from completion. If workmanship fails, we make it right. Calls are answered by a live person 24/7, and technicians arrive background-checked and in uniform. Call (888) 255-9354 to book your free estimate.
Get a Free Estimate for Vanities, Tile & Fixtures in Laguna Hills
Call (888) 255-9354 to schedule a free on-site estimate. We’ll measure the room, check the existing plumbing and substrate, and hand you a written line-item price before any work starts. Projects over $10,000 get $1,000 off, and 0% financing for 18 months is available. Live person on the line, any hour.
Written by the team at Groundwork Construction Co.












