







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Irvine, CA: What It Costs and How Long It Takes
A chain link fence in Irvine typically runs $3,500 to $9,000 installed, and most residential lots are finished in one to three days once we’re on site. The number that lands at the high end is almost always driven by linear footage, height, gate count, and whether the fence sits on a slope or backs up against HOA-reviewed common area. Call Groundwork Construction Co. at (888) 255-9354 for a free on-site estimate with line-item pricing, so you know what you’re paying for before anyone digs a hole.
How We Build a Chain Link Fence, Start to Finish

Every chain link job follows the same order of operations. Here’s what actually happens, day by day, and where your decisions land.
Stage 1: Walk the line and call in the utility locate (day 1)
We start by walking the property line with you and marking corners and gate posts. Then we call in the utility locate and wait for it to clear before a single shovel touches dirt. That wait is usually a couple of days, and it’s non-negotiable. Hitting an irrigation line or a gas stub costs far more than the delay.
Stage 2: Demo and layout (day 1 – 2)
Old fencing comes out, along with any concrete footings that are in the way. We set string lines and confirm post spacing, typically 8 to 10 feet on center. If the fence line needs to shift to stay inside your property line or clear an HOA setback, this is the moment to move it. Once posts are marked, changes get expensive.
Stage 3: Dig, set, and pour (day 2)
Terminal posts, corner posts, and gate posts get set in concrete first because they carry the tension. We dig holes sized to post height and soil, set posts plumb, and pour. Line posts follow. Concrete needs to cure before the fence wants tension, so this is where the schedule breathes.
Stage 4: Rails, mesh, and tension (day 3)
Top rail rolls out and couples through the line posts. Chain link mesh gets stretched and tied off. Gates get hung and adjusted so they swing clean and latch without a fight. A fence that looks fine but sags after the first Santa Ana wind event was stretched wrong on this day.
Stage 5: Walkthrough and cleanup (day 3)
We walk it with you, check tension, gate operation, and post plumb, and haul off the old material and concrete debris. Any punch-list item gets addressed before we leave. Your project is covered by the 730-Day Done Right Promise, and we put that in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
- Galvanized vs. vinyl-coated mesh: Bare galvanized is the value pick and handles Irvine’s dry climate fine. Vinyl-coated (black or green most often) adds cost but looks cleaner against stucco and landscaping. Both hold up; vinyl wins on appearance.
- Height: 4-foot is a boundary marker, not security. 5-foot is the common residential middle ground. 6-foot is what most homeowners choose when the fence needs to do real work.
- Gauge: 11.5-gauge mesh lasts longer than 12.5-gauge but costs more. On a lot with kids, dogs, or foot traffic along the line, the heavier gauge pays for itself.
- Framework: 1-5/8″ line posts and top rail are standard residential. Heavier posts on corners and gates are worth the upgrade; that’s where fences fail first.
- Gates: Walk gates are simple. Double-drive gates need heavier framing and better hardware, and they’re where most of the cost creep happens.
- Tension wire and top rail: A tension wire at the bottom keeps mesh tight and blocks dogs from pushing through. Skip it and the fence looks tired within a year.
What Chain Link Fence Costs in Irvine, CA

Expect $3,500 to $9,000 for a typical residential chain link fence in Irvine. Here’s what moves the number:
- Linear footage: The dominant variable. A small side-yard run stays near the low end; a full perimeter pushes toward $9,000.
- Height and gauge: Moving from 4-foot to 6-foot with heavier mesh adds meaningful cost per foot.
- Gates: Each gate adds hardware and framing. Double-drive gates add more.
- Terrain: Slope and rocky soil slow the dig and sometimes require deeper footings.
- Demo and haul-off: Removing an existing fence and its concrete footings is real labor.
A written estimate itemizes footage, height, gauge, gate count, demo, and haul-off, so the total makes sense line by line. Upfront pricing, no surprises: the number you see is the number you pay. If you’re also repaving or pouring hardscape, homeowners often pair this with Concrete Driveways & Concrete Work in Irvine or Asphalt Driveways & Resurfacing in Irvine so the whole exterior gets worked in one pass. call us for exact numbers on your lot.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine Homes Specifically Do to This Job
Irvine is a master-planned city built largely by the Irvine Company from the 1970s on, which means almost every fence here runs inside a village association with its own architectural rules. Before we set a post, you need HOA sign-off on height, material, and color, and in many villages the fence line has to match a common-area standard. That approval step is what separates an Irvine chain link job from one in a surrounding city with older, unplanned stock. If the fence is part of a larger project, it folds into Fence Installation in Irvine cleanly.
The housing stock skews toward stucco and tile-roof tract homes and attached townhomes in villages like Woodbridge, Northwood, and Turtle Rock, so fence lines often share a property edge with a neighbor or a common slope. Wind is the other factor. Santa Ana events push hard against a fence that wasn’t tensioned properly, which is why corner and gate posts get heavier framing on this side of Orange County. We handle these jobs throughout Irvine, including 92602, 92617, 92619, and 92604.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Irvine

Most residential jobs are done in one to three days once we’re on site, not counting the utility locate wait beforehand. Larger perimeters, double gates, or slope work can push past three days. Call (888) 255-9354 for a timeline based on your lot.
Yes, plan on both. Irvine village associations require architectural review before installation, and the city has its own requirements depending on height and location on the lot. We’ll walk you through what your association needs and confirm the scope before work begins.
In most cases, yes. We dig only at post locations, so the damage is contained to those spots. Any turf or irrigation line we cross gets tracked and repaired. call us if you have a specific area of concern.
Typically $3,500 to $9,000 installed, depending on footage, height, gauge, and gate count. call (888) 255-9354 for an exact quote; estimates are free.
Yes. Every chain link fence we install is backed by the 730-Day Done Right Promise. If something isn’t right, we make it right. That’s in writing.
Get a Free Chain Link Fence Estimate in Irvine
Every free estimate starts with a walk of your property line. We measure, note slope, gates, and HOA considerations, and hand you an itemized price you can compare against any other bid. Upfront pricing, no surprises. Call Groundwork Construction Co. at (888) 255-9354 and a live person answers around the clock. Better yet, look at this as part of your full Fence Installation plan.
Written by the team at Groundwork Construction Co.












