







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Driveway & Pavers: The Yorba Linda Owner’s Guide
We install and repair Boral driveway and paver systems throughout Yorba Linda. A full Boral paver driveway typically runs $7,000 – $18,000 installed here, and a paver patio runs $3,500 – $11,000. Most Yorba Linda homeowners call us after they notice a specific symptom: a handful of pavers in one traffic lane have dropped 1/8 to 1/4 inch below their neighbors, water pools against the garage apron instead of sheeting off, or the joint sand has washed out along the driveway’s downhill edge after a January storm. Those aren’t cosmetic problems. On Boral’s permeable and interlocking systems, they’re the first visible sign that the base layer or the joint system has failed underneath.
Which Boral Models This Applies To
Boral’s driveway and paver line covers several distinct systems, and the part you need depends entirely on which one you have. Permeable interlocking concrete pavers (often installed for Yorba Linda’s stormwater-conscious remodels) use a specific open-graded joint aggregate, not ordinary bedding sand. Boral’s traditional concrete pavers and its stone-textured lines use a standard ASTM C144 joint sand and a compacted Class II base. The edge restraint is where compatibility gets tricky: Boral specifies a paver edge restraint with a defined spike length and embedment depth, and owners who substitute a generic plastic edge strip end up with a paver run that creeps within two or three seasons. Walk your driveway and look for a stamped or printed marking on a corner paver or an exposed edge unit. Failing a label, measure a single paver face and photograph the profile from the edge; the thickness, the chamfer and the interlock pattern identify the series more reliably than color alone. We source genuine Boral components and verified aftermarket equivalents that meet the same spec, and we’ll tell you plainly which one your system actually requires.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boral Driveway & Pavers Is Failing
- Pavers sitting lower than their neighbors. This usually means the bedding layer has consolidated unevenly, often over a spot where the subgrade wasn’t recompacted or where runoff has been infiltrating for months. It’s a base problem showing up at the surface.
- Water pooling at the garage apron or against the house. When the paver field settles, the slope that should carry water away gets lost. In Yorba Linda, where the hillside lots shed water fast and hard, a shallow depression near the apron can push runoff toward the stucco instead of the street.
- Joint sand washing out, especially on the downhill edge. Missing joint aggregate isn’t just untidy. Without it, pavers lose their lateral lock, and a permeable system loses the layer that filters water. Heavy winter rain here exposes poor joint work within a single season.
- Rutting or creeping in the tire lanes. Often a sign the edge restraint has pulled loose or was never set at the proper embedment depth. Once the perimeter opens up, the whole field shifts under vehicle weight.
- Efflorescence and spalling on a handful of units. White mineral bloom that recurs, or surface flaking, can point to moisture trapped in the base or a localized bond failure. Single-unit spalling on older pavers sometimes just means replacement of that course.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Boral paver driveway installation in Yorba Linda runs $7,000 – $18,000 installed, and a paver patio runs $3,500 – $11,000. The range is driven by square footage, whether the existing driveway has to be demolished and hauled, how much excavation and base material the site needs, and whether your system is permeable or standard interlocking. A targeted repair (lift and re-bed a failing lane, reset the edge restraint, re-sand the joints) costs far less than a full replacement and is often the right call when the failure is confined. You get upfront pricing with no surprises: a written line-item quote that separates materials from labor, fixed before we start, with no change orders mid-job. Every driveway and paver project we install is covered by our 730-Day Done Right Promise, so a base or joint problem that shows up inside two years comes back to us to make right at no additional cost to you.
DIY or Call Us?
You can safely do the looking. Photograph the paver profile, note where the field has settled, check whether the joint sand is gone, and look for the edge restraint along the driveway perimeter. What you shouldn’t take on is the compaction and re-bedding work. Getting the base right means excavation to the correct depth, layered and mechanically compacted Class II aggregate, and an edge restraint set at Boral’s specified embedment. Skip any of that and the pavers will settle again before the next rainy season, and on these hillside lots that means water heading for your foundation. Lifting and re-seating pavers to the wrong base spec is worse than leaving them alone. Call us at (888) 255-9354 and we’ll pinpoint whether you need a targeted repair or a full reset, then quote it in writing.
FAQs

Installed over a properly compacted base with the correct joint aggregate, Boral concrete pavers commonly hold up 25 to 30 years or more. The pavers themselves usually outlast the installation that holds them, which is why base and edge restraint failures cause most of the problems Yorba Linda owners call us about, not the paver units. Call (888) 255-9354 for an exact assessment – estimates are free.
Yes, and often they should be. When the failure is confined to one lane, a single course, or a loose edge restraint, we lift the affected units, correct the base, reset the pavers, and re-sand the joints rather than tearing out the whole driveway. A full replacement makes sense only when the base has failed broadly or the field has settled across the entire footprint.
A targeted repair such as re-bedding a lane or resetting an edge typically takes a single day. A full driveway replacement is a multi-day job once you account for demolition, excavation, and compaction. We’ll give you the realistic timeline in the written estimate, not a guess.
We match your marking or measured profile to the correct Boral series specification, then source genuine Boral components or a verified aftermarket equivalent that meets the same thickness and load spec. We carry no parts on a truck and hold no stock for every series, so we confirm the exact part your system needs before we order. Call (888) 255-9354 to start your free estimate.
We’re an independent service provider, not affiliated with Boral. Alongside Boral driveway and paver work, we install and service KraftMaid, Cambria, and Silestone products across our other trades. Groundwork Construction Co. of Yorba Linda answers every call with a live person, 24/7, and sends background-checked, uniformed technicians on every project. Our technicians bring up to 12 years of experience, and every job is built to last, backed in writing.
Written by the team at Groundwork Construction Co. of Yorba Linda, serving Yorba Linda and nearby areas.












